GitLab

[[http://wiki.seeedstudio.com/Arch_Link/]]
Signed-off-by: Wojciech Dubowik <Wojciech.Dubowik@gmail.com>

Added decaWave DWM1001-DEV board

- GPIO0 and GPIO1 on the DWM1001 are attached to the DW1000 not the
nRF52
- Removed 2 digital pins
- Shifted all the numbering

- Replaced '-' with '_'

Added GPIO pin mapping note to nRF52 DK

Updated for Release 0.5.1

Fix BMP on non-Windows platforms

Enable cut and paste installation on Linux

As per https://github.com/sandeepmistry/arduino-nRF5/issues/245#issuecomment-367428563

Make it possible to install noninteractively by copy&paste

Fixed formatting from last update.

Cleaned up listing for Nordic development kits

Updated 0.5.0 Release

* define Reset-Pin for nRF52 platforms.
Signed-off-by: Hubschneider Joerg (INST-IOT/ESW-Wa) <joerg.hubschneider@bosch-si.com>

The problem (at least in the case of the I2C scanner that I had to deal with) was related to an empty tx buffer, so the LASTTX event never occurres, resulting into an endless loop.

Add -D{board.variant} to build.extra_flags of PCA1000X softdevices

Add PCA1000X variant PCA10001

* Added Sino:bit board, including HT1632,AdaFruit GFX and Dave Astels Sinobit Library

* Removed 3rd party libraries and modification of JSON

* Removed and ignored .vscode folder

* Removed unecessary comments in variant.cpp, Corrected include guard name in variant.h

* Add some new lines

* Remove stray define

* UART: Add setPins(...) for generic boards (nRF51 and nRF52).

* SPI: Add setPins(...) for generic boards (nRF51 and nRF52).

* Wire (I2C/TWI): Add setPins(...) for generic boards (nRF51 and nRF52).

* set a reset pin if RESET_PIN is defined in variant.h

* move setting of reset pin to wiring.c

* remove leftover code

* In support of 'issue' #183 - Add Black Magic Probe (BMP) upload method
This is basically a merge of work done by @rogerclarkmelbourne in arduino-nRF5-customised, with the addition of bootloader uploading as per @sandeepmistry openocd reference in platform.txt
Note: This incorporates changes based off feedback from @sandeepmistry, @dmikhalsky, @dlabun
* README.md - BMP driver installation details
* platform.txt - BMP tool setup
* programmers.txt - Add BMP as a programmer option

* In support of 'issue' #183 - Add Black Magic Probe (BMP) upload method
This is basically a merge of work done by @rogerclarkmelbourne in arduino-nRF5-customised, with the addition of bootloader uploading as per @sandeepmistry openocd reference in platform.txt
Note: This incorporates changes based off feedback from @sandeepmistry, @dmikhalsky, @dlabun
* README.md - BMP driver installation details
* platform.txt - BMP tool setup
* programmers.txt - Add BMP as a programmer option

* Update programmers.txt

Remove accidental references to sandeepmistry:openocd for openocd methods

* Update programmers.txt

* * rename bmp programmer to the more descriptive blackmagicprobe

* * remove accidental addition of bootloader.tool to openocd methods

add support for Electronut labs hackaBLE module